By Easy Mount

A sturdy portable base to support your satellite antenna. The Port-A-Base is nearly indestructible and is only two inches high for easy R.V. storage. This sturdy solid rubber base weighs over 20 pounds to ensure your dish remains on solid ground without additional support. No need to fill gallon jugs with water or use other means to prevent your dish from accidentally tipping that is necessary with other dish support systems. Your dish is on top of firm support with Port-A-Base and locked down tight with stainless steel mast locking screws.

Port-A-Base can be used as the primary satellite antenna support or an easy to store, backup satellite antenna support for those times when the R.V. mounted antenna cannot receive a signal. As the Port-A-Base is made of rubber and cannot rust or break. Store Port-A-Base under anything, it takes up very little space. Port-A-Base is also used in many other applications either temporary or permanent mounting when other mounting methods are not possible. Antenna Not Included Email easymountport-a-base@att.net or call toll free 877-517-5704.

Freight is $13 for Zone 2-5 and $20 for zones 6-8 based from Portland, OR.

Port-A-Base
By Easy Mount
Set up

Step 1. Place the Port-A-Base on any surface and make sure it does not rock. Do not worry about it being level. Check to see if you have an unobstructed view of the southern sky. If not move the Port-A-Base until you do

Step 2 Attach your Antenna mast to the Port-A-Base using the 4 thumb screws provided. Use a level to make sure the upper mast is plum (level) as shown. Secure the masts locking screws near the base. Use a compass to determine south. The upper end of the mast must be level on its South side.

Step 3. Now that the upper end of the mast is level and secured, mount the antenna on the mast. Finish the antenna set up as outlined in your satellite manual and on the screen of the TV.